Basic functions
21
Key 1: - + 1
Key 0: . : _ 0 space
Key #: @ / #
You can use the -key to toggle between digit and letter input as well as upper and lower case.
BASIC FUNCTIONS
REMOVING THE PHONE FROM THE CHARGER CRADLE
To remove the phone from the charger cradle, tilt the phone slightly to the front/upright position
and lift the phone to avoid the cradle being lifted along with the phone.
SWITCHING THE DECT PHONE ON/OFF
Switching the DECT phone on
Press and hold the End key ( ) until the display lights again. This can take up to 10 seconds.
Switching the DECT phone off
Press the End key ( ) and hold it down for a moment
or …
Press the End key ( ) briefly, select Switch off and press Ok.
The DECT phone switches off after a confirmation prompt.
KEY LOCK/PHONE LOCK
Switching on the key lock
Press the hash key ( ) and hold for a moment. The key lock is activated and the Unlock symbol
( ) appears in the display.
Switching the key lock off
Press the softkey and then press the hash key ( ) within 3 seconds.
Releasing the phone lock
If you have locked your telephone to prevent unauthorized use (see “Security menu” on page 57),
you can release the lock again by pressing the Lock softkey ( ) and entering your PIN.
Note: If the DECT phone is switched off when placed in the charger cradle, it remains off
but continues to be charged. The LED flashes red/green alternately to indicate that the
DECT phone is charging.
For technical reasons the switched-off handset can switch itself on when placed in the
charger cradle if it is removed from the cradle again before the red / green flashing LED
is displayed.
To Next Page
Loading...
