Mitel 700 DECT Phone User Guide
22
UNLOCK A LOCKED DECT PHONE BY MASTER RESET
The DECT phone can be reset to factory defaults if the DECT phone is protected with a PIN, and
no other option can be used to unlock the phone. For example, set a new PIN through the OMM
to a known value.
If a wrong PIN was successively entered 3 times, then a reset procedure can be activated by
going to the Menu ••• and entering “***778#” as the code and “Master” as the password.
The DECT phone needs to be subscribed with a DECT system after the reset.
SWITCHING HANDS-FREE OPERATION ON/OFF
Press the loudspeaker key ( ) to switch hands-free operation on or off.
The Speaker symbol ( ) appears on the display if the hands-free operation feature is enabled.
If you make a call and place the DECT phone in the charger cradle, the hands-free
operation feature is automatically activated. Do not hold the DECT phone up to your ear
in hands-free mode or when the ringer is ringing as the volume can be very loud.
Note the following behavior of hands-free operation:
1. When the phone is in idle state, the volume settings are available on the hands-free key.
2. When the phone is in predial state, the hands-free key will start a call in hands-free mode.
3. When the phone is in ringing/alert state, the hands-free key will accept the incoming call in
hands-free mode.
4. When the phone is in active state, the hands-free key will toggle hands-free in the following
order:
a. Hands-free > Earpiece > Hands-free > Earpiece
b. Hands-free > Bluetooth > Hands-free > Bluetooth
c. Hands-free > Corded headset > Hands-free > Corded headset
ACKNOWLEDGING AN APPOINTMENT OR REMINDER
You are notified of an appointment or reminder by the specified ringer and the LED flashing red
for approximately 45 seconds. The display shows the corresponding text. You can acknowledge
the notification by pressing the Esc softkey.
ADJUSTING THE VOLUME OF THE EARPIECE DURING A CALL
Press the upper or lower side-key to increase or reduce the volume of the call currently being
made. If the keys are programmed with functions, use a long key-press first. You can then adjust
the volume by briefly pressing the key as required.
Note: Be aware that this Master reset deletes all data from the DECT phone.
To Next Page
Loading...
