Mitel 700 DECT Phone User Guide
52
SYSTEM MENU
Note: All settings in this menu take effect only after the entries have been confirmed with
Save!
New system
Enter the access code and optionally the PARK code.
Contact your System Administrator for more information about this and about the protocol setting.
Subscription
Auto Search The DECT phone automatically logs on to the system with the strongest
signal currently available. Logon is possible only if the DECT phone has
subscribed to the system beforehand.
Contact your System Administrator if required.
[System 1...10] List of systems to which the DECT phone is already subscribed. The
selected system is highlighted.
Use the navigation keys to select a system. With the DECT phone tries
to establish a connection.
Other options can be obtained and set by pressing •••. As a rule, they do
not have to be changed.
The following settings should be made only by the system
administrator (but only if the system does not provide defaults):
• System Name and Phone number let you change or enter the system
name and phone number. This is possible only if no details are supplied
by the system.
• External call is used to set the code that identifies external calls (e.g. 0).
• Internal call is used to set the number of digits that make up an internal
phone number. Both settings allow the device to differentiate between
internal and external calls.
• Character set is used to set the Editor’s character set.
• Protocol* is used to set the transmission protocol.
• Details shows additional device data.
• Delete is used to delete the subscription for the corresponding system.
Stop searching
Used to specify that the handset is not present within the system.
This feature is useful in some systems if the system fails to detect
that the device is switched off, and in this case, activates a call
diversion, for example.
Security observation
You can select the security observation level for DECT Security. Resets and changes
from security level are PIN protected.
To Next Page
Loading...
