Mitel 700 - CALLING FROM THE SYSTEM’S CALLER LIST; ENDING CALLS; OPTIONS DURING A CALL; ANSWERING A CALL DURING A CALL (CALL WAITING)

Mitel 700 DECT Phone User Guide
36
CALLING FROM THE SYSTEM’S CALLER LIST
Check to see which list (local / system) has been set on the display (see “List access” on
page 56). Depending on whether or not the phone number is transmitted, your communication
system stores the phone numbers of missed calls or calls made while the phone was busy.
Depending on the system equipment, 30 or 50 entries can be stored.
ENDING CALLS
OPTIONS DURING A CALL
If required you can select a call number from the available lists and dial into an existing connection
(DTMF suffix dialling).
ANSWERING A CALL DURING A CALL (CALL WAITING)
If you do not want to be disturbed, you can switch off the call waiting function (see “[System
Menu] menu” on page 53).
Note: You can also access the Info menu/Call list using the Navigation menu (see “Softkey
line and idle display” on page 15) or via the Menu Access ••• when the DECT phone is in
the idle state.
In idle mode, press the left navigation key. The Info menu appears.
Use the navigation keys to select
Caller list, then the name or the phone number. Press
Ok to display additional information about the entry.
Press the Call key (green). The selected entry is called.
Note: You can also access the Info menu/call list via the Navigation menu (see “Softkey
line and idle display” on page 15) or via the Menu Access ••• when the DECT phone is in
idle mode.
You can end calls by pressing the End key.
Press ••• and select a call number from the following lists:
• Personal directory
• Redial list
• Caller list