Mitel 700 - CALL ROUTING; CALL DIVERSION; SYSTEM; SYSTEM MENU

Mitel 700 DECT Phone User Guide
42
CALL ROUTING
If supported by the system, allows you to route incoming calls to one or more pre-programmed
destinations.
CALL DIVERSION
Call diversion enables you to forward calls to other internal / external phones. A call can be
forwarded immediately, when the connection is busy or after a certain time.
Note that if the "Call Forward" XML hook is activated, Call Diversion is de-activated and replaced
by the Call Forward service. Consult your System Administrator for more information.
SYSTEM
In this menu you can specify the active system for your handset, and administer registrations to
different systems. You can also read the IPEI number and information on the status of hardware
and software.
SYSTEM MENU
This menu enables you to set automatic call-back and call waiting functions.
SETTINGS
This menu provides access to device settings, such as key lock, key programming, user name,
display settings, illumination, Bluetooth, etc.
PROTECTION FUNCTIONS
This menu can be accessed via the PIN (Personal Identification Number). On delivery, it is 0-0-0-0
(4 x zero). You can block the DECT phone (lock), change the PIN, program an emergency number,
enter settings for the alarm sensor (Mitel 732d and 742d), as well as completely or partially reset
the DECT phone to factory settings.
PROFILES
This menu is used to create and administrate user profiles. Five profiles are preset, however you
can modify them.
FEATURE ACCESS CODES
This menu allows entry of Feature access codes (FAC) to control various functions in your system.
FAC entry is only offered if supported by your system.
INFO MENU
Caller List Displays the entries in the local caller list or the system’s caller list. If a phone book
entry has been created for a phone number (either on the handset or in the system),
the corresponding name is displayed.