Handling Calls
33
MAKING INTERNAL / EXTERNAL CALLS
If you see the message “No record!” when dialling a phone number, your phone may be blocked
by the system. If so, notify your System Administrator.
Correcting your input during predial
• To delete individual digits, briefly press the C key.
• To delete the entire phone number, press and hold the C key.
Toggling between digit and letter input (where supported by the system)
Press the * key several times.
• Digit input: display reads 123
• Letter input – upper case, then lower case: display reads Aa
• Letter input – upper case: display reads A
• Letter input – lower case: display reads a
Setting the character set
During character input you can change the character set by pressing •••. The selected setting is
then adopted as the default (inputs begin with either digits or letters). This setting can be reset
temporarily during the input by pressing the * key once again.
CALLING FROM THE REDIAL LIST (LOCAL / SYSTEM)
Check to see which list (local / PBX) has been set on the display (see “List access” on page 56).
The local list contains the phone numbers of the last 30 phone numbers dialed. If you are using
Briefly press the Call key.
and/or
Press the key for the internal or external phone number, preceded by the code to access
external lines.
Press the Call key.
... or
Press ••• and select phone number from one of the following lists:
• Caller list
• Redial list
• Personal directory, Central directory
If you enter the start of a number and press the softkey, the DECT phone searches
the personal directory for all names and numbers that start with this number sequence.
Select the required entry and press Ok.
To Next Page
Loading...
