Mitel 700 - Data Management; SD Card Menu; Call Filter Menu

Mitel 700 DECT Phone User Guide
50
DATA MANAGEMENT / SD CARD MENU
Mitel 722dt, 732d, and 742d only: This menu is available only when your handset is equipped
with an optional Mitel microSD card (see “MicroSD card” on page 9). Other data can be stored
on the card in addition to the device settings.
CALL FILTER MENU
The call filter allows you to answer or block incoming calls.
• The Accept list setting only allows the call numbers in the call number list to be signalled
(no other numbers).
• The Block list setting means all calls are signalled except the calls from the call numbers in
the list.
If Unknown number is activated, incoming calls without Caller ID will also be blocked or
signalled. The call number list can contain 10 entries.
Engine room • There is no increase of the maximum handset volume.
• An AGC function (automatic gain control) is activated to enable
automatic adaptation of the microphone to the respective
environment.
• The microphone is attenuated by 6 dB, the ambient noise is
attenuated or the opposite side can hear you much better, but by
reducing the background noise, speech becomes more intelligible.
Audio quality
This menu entry is only available if your system supports Wideband Audio.
If the handset is used in reflection-prone environments (e.g. metallic workshops), there may be
interference with the DECT reception. Mitel XQ technology can be used in these areas in order
to prevent this interference.
When Wideband Audio G.722 is enabled in SIP-DECT, the Menu>Audio>Audio quality option
is available on the subscribed Mitel 7x2d phones to enable the disable the wideband speech
option.
The following settings can be used to prevent connection failures in XQ areas.
Standard Audio Set this (normal) speech quality if interference may occur (e.g. in XQ
areas).
Wideband Audio Attempts to establish a connection in high speech quality audio.
Automatic Attempts are always made to establish a connection in high speech
quality. If the device is located in a XQ-protected environment, then
incoming or outgoing connections are made in standard speech
quality. Switch on this mode if you switch regularly between areas
(XQ / office) and still wish to use Wideband Audio in the office.
Status
You can change the filter mode.
Accept list Calls for the call numbers entered in the list are accepted.
Block list Calls for the call numbers entered in the list are rejected.