Device menu
49
Silent charging When this option is selected, the DECT phone does not ring for any calls
when it is in the charger cradle. When you take the DECT phone out of
the charging cradle, calls are audibly signalled again. The calls are
recorded in the call list.
Silent Charging does not apply when the DECT phone is charged using
the USB connector. This setting can also be changed in the Device
options menu.
Ringer Switches all the ringer entries on the list on or off. This setting can also
be changed in the Volume Settings menu.
Vibra call Select whether the call is also to be signaled with the vibration alarm.
This option is not available on the Mitel 712dt.
Corded headset Select whether the call is also to be signaled on the headset.
Noise detection When this function is active, the volume of the ringer is automatically
increased if there is loud background noise. If you want to use this
feature, make sure that the ringer volume is not set to Increasing.
Attention tones
Select whether the respective attention tones and vibration should be activated or not.
Key click A confirmation sound is played when a key is pressed.
Confirm tones Confirm successful and unsuccessful settings.
End of menu Alert when reaching the end of a menu list.
Battery warning Alert when the battery is almost empty.
At this indication, only a few minutes remain before the call is
disconnected.
Coverage warning Alert when the wireless connection strength has decreased to the point
where there is a risk of disconnection.
Out of range Alert when the handset is out of range.
Pre-alarm Mitel 732d and 742d only: This is the alarm tine sounded during the
pre-alarm (triggered by the Alarm sensor). The setting can be set in
parallel in the menu Alarm Sensor.
Environment
The DECT phone attempts to improve the voice transmission (does not apply to connections
made with the Bluetooth headset and in hands-free mode) if used in different environments. If
a user switches between quiet and noisy environments, it is useful to create corresponding
audio profiles in the DECT phone with the desired audio settings.
Normal environment No adjustments are made to the microphone and maximum earpiece
volume.
Noisy environment • No adjustments are made to the maximum handset volume.
• An AGC function (automatic gain control) is activated to enable
automatic adaptation of the microphone to the respective
environment.
To Next Page
Loading...
