Mitel 700 - Page 56

Mitel 700 DECT Phone User Guide
48
Alarm message Changes the currently set volume for alarm messages (when supported
by your system).
Note: The ring tone for alarm messages cannot be turned off.
Note: With the softkey you can switch the ring tone off or on (except for VIP
calls, Special calls, SOS calls, and Alarm messages). If the ring tone is switched off,
the icon will be displayed as a reminder.
You can also switch the ring tone off / on by pressing and holding down the Star key
(with the DECT phone in the idle state). Attention tones (see Melodies) are always
signaled with the volume of the Internal call.
Melodies
Internal call Changes the currently set melody for calls from internal subscribers.
External call Changes the currently set melody for external calls.
Unknown number Changes the currently set melody for calls without transmitted caller
number.
This setting is not supported by your system.
Callback Changes the currently set melody you hear as a callback. Example: You
have put a connection on “Hold” but – within a certain time – not dialed
another call number, you will get a callback that reminds you about the
waiting subscriber (see “[System Menu] menu” on page 53).
Recall Changes the currently set melody for recalls.
This setting is not supported by your system.
VIP call Changes the currently set melody for calls from VIP call numbers. See
“VIP list (Mitel 712dt)” on page 28 and “
VIP list” on page 45.
Special call Changes the currently set melody for special calls.
This setting is not supported by your system.
SOS call Changes the currently set melody for incoming emergency calls.
Alarm clock Changes the currently set melody for the alarm clock.
Appointment Changes the currently set melody for appointment notification.
Normal message Changes the currently set melody for normal messages (when supported
by your system).
Urgent message Changes the currently set melody for urgent messages (when supported
by your system).
Alarm message Changes the currently set melody for alarm messages (when supported
by your system).
Note: You can listen to the melody with the softkey before saving. You can choose from
44 polyphonic MIDI ringer melodies, 8 normal ringing tones (Basic), 7 alarm tone sequences
and 9 attention tones.
At an incoming call, attention tones will be played only once. There are five additional melodies
(6700, etc.), which are similar to the ring tones of the Mitel 6700 series DECT phones.
Ringer settings
Play once Select whether the call tone melody should be played once or repeated.