Device menu
61
PROFILES MENU
When the DECT phone is delivered, it has four profiles with pre-programmed settings. A fifth
profile is available for further settings. You can change all profiles and rename them if required.
The activated profile is displayed beside the Profile symbol ( ) on the idle display.
LOG IN/LOG OUT
This menu can be used to Log in and Log out to the DECT phone.
FEATURE ACCESS CODES MENU
This menu is system specific and is only offered when the functions are supported by your system.
It allows the input of certain strings (e.g. to park a line or to leave a call-back request). Contact
your system administrator for more information about these functions.
Select: No profile
No profile can be used with this setting. The settings you
select apply.
Normal
Parameters for normal use are configured in this profile.
Headset
Parameters for using a headset are preset in this profile.
Meeting
Parameters for using the handset during meetings are
present in this profile.
Loud
Parameters for use in loud environments are preset in this
profile.
<Profile 05>
This profile is for your custom use.
Settings Choose one of the profiles to make changes.
Profile name
Change the name of the profile, if required.
Ringer volume
Set your preferred ring volume: Increasing or a setting
between 1 and 7.
Ringer device
Configure where and how ringer signaling will be done:
Ringer, Vibra call, or Corded headset.
Play once
Select whether the ringer should ring once or repeatedly.
Key click
Switch the key click on and off.
Confirm tones
Switch the confirmation tones on and off.
Noise detection
Switch the automatic noise detection for a louder ringer on
and off.
Environment
Adapt the speech quality in different environment.
Silent charging
Switch Silent charging on and off.
LED incoming call
Switch the LED indicator for an incoming call on and off.
To Next Page
Loading...
