236
(4) Errors
If a dedicated instruction ends with an error, Completion device (D1)+1 turns on, and the error code is stored in
Completion status (S1)+1.
(5) Program example
The following pages show sample programs that change the following setting items using the UINI instruction.
• Ethernet operation setting
• Transmission speed and communication mode
The following are sample programs for communications using connection numbers 1 and 2. When using other connections,
specify the corresponding signals and bits for each connection.
The UINI instruction is also used in the program for a reinitialization process. When performing a reinitialization
process using the UINI instruction, refer to the program for a reinitialization process. ( Page 315, Appendix
4.2)
To Next Page
Loading...
