Mitsubishi Electric MELSEC-L Series - CHAPTER 16 TROUBLESHOOTING; Troubleshooting Procedure

237
CHAPTER 15 DEDICATED INSTRUCTIONS
15
15.13 ZP.UINI
(a) Changing the Ethernet operation setting
The following page provides a sample program that changes the Ethernet operation setting (enables writing
during RUN) (when the I/O signals of the E71 are X/Y00 to X/Y1F).
Specify the change
in the operation setting.
Read the current
operation setting.
Set "Enable Online
Change".
Process upon completion
Process upon abnormal end
Communications enabled
Process upon completion
Process upon abnormal end