Mitsubishi Electric MELSEC-L Series - Page 337

335
APPENDICES
A
Appendix 7 Differences from Ethernet Modules of Other Series Appendix 7.3 Differences from QnA/A series modules
(1) Functional comparison
The following table lists the functional comparison.
: Supported, : Not supported
Function AJ71E71
AJ71E71-S3,
AJ71E71N
QE71(N)
E71
9706 or
earlier
9706B or
later
Initial process
Initial process with the program 
Initial process with parameter settings 
Open process
*1
Open process with the program 
Open process with parameter settings 
Communications using a
fixed buffer
Procedure Exist 

*2
No Procedure 

*2
Communications using a random access buffer 
MC protocol communications 

*3

*3
Communications using data link instructions 

*4

Interrupt process (upon
data receiving)
BUFRCVS instruction 
RECVS instruction 
E-mail function
Send/receive with the program 
Send with the auto notification function 
File transfer (FTP server) function 
Web function 
Broadcast communications 
Communications with the switch on the CPU module set to STOP 
Selection of the communication data code (ASCII/binary) 
CC-Link IE Controller Network, CC-Link IE Field Network,
MELSECNET/H, MELSECNET/10 relay communications


*4

Router relay function 
Connected device alive
check
Ping 
KeepAlive 
Pairing open 
Unit of each timer setting
value for data
communications
500ms

*5
 (Fixed)  (Fixed)  (Fixed)
2s  (Fixed) 
Connection to
MELSOFT products
TCP/IP 
UDP/IP 
Installation of EEPROM 

*6
TCP Maximum Segment Size Option transmission 

*7


*7

*8
Hub connection status monitor function 
IP address in use detection function 
Communications using SLMP 

*9
Data communications using the predefined protocol 

*9
Module error collection function 