44 User Guide EN Dansensor® MAP Check 3 Vacuum
P/N 320598-G
11/2019
233 Error Too high bypass flow (V2,V4 Problem ?) Check flow
system hoses
234 Error Too low bypass flow (V2,V4 Problem ?) Check flow
system hoses
235 Error Too high bypass flow (V1,V4 Problem ?) Check flow
system hoses
236 Error Too low bypass flow (V1,V4 Problem ?) Check flow
system hoses
237 Error Sensor flow too low Check flow
system hoses
238 Error O
2
% reading is out of range 19.9 .. 21.9 % Check flow
system hoses
239 Error Cannot reach Leak test pressure Check leak target
setting or
vacuum supply
240 Error Connect calibration gas to both Cal gas inlet and
Buffer Inlet
Contact service
241 Error Connect pressurized gas to Buffer inlet Check buffer gas
242 Error Could not obtain target pressure Check buffer gas
243 Error Connect vacuum to Vacuum inlet Check vacuum
244 Error Sample system clogged. Check hose for blockages. Check filter in
sample gas
probe
No. Type Message User action
To Next Page
Loading...
