Monaco Cayman 2005 - Dinette Bed Conversion (Opt); Storage - under Bed

Equipment --- Section 5
Cayman 2005
193
To Deflate the Mattress:
1. Remove bedding items.
2. Unzip the corner of the mattress where the air valve is located.
3. Lift the valve release.
4. Once deflated, close the valve release, zip the mattress cover and lose the convertible sofa.
Electric Bed:
The newest generation of sofa sleeper is the electric bed. This sofa uses 12 Volt DC to operate the
slide mechanism.
STORAGE - UNDER BED
To use the storage compartment located under the bed,
locate and unlock the bed deck latches. Lift up the bed by
the front edge of the mattress platform. Gas struts hold
the mattress and platform open.
NOTE:
Do not over stress gas struts by rapidly open-
ing or losing the bed access cover, as this action
can damage the struts or mounts. In extreme
cold, gas struts may not hold the mattress plat-
form in the open position.
DINETTE BED CONVERSION (Optional)
To Convert Booth Dinette into a Bed:
• Lift seat cushions to an angled vertical position.
• With a firm grip, lift front edge of the table
approximately six inches and push table leg lock
to side.
• Swing the table leg up and lock into a horizontal
position.
• Continue lifting table until table stays are clear of
retainers. Pull outward and lower table down.
• Use both seat cushions and one back cushion for a
mattress. Leave one back cushion in a vertical
position.
WARNING:
Do not occupy the booth dinette, if not equipped with safety belts, or the dining chairs
while the motorhome is in motion. To avoid personal injury to occupants in case of a
crash or sudden stop, chairs must be stored in an enclosed area or secured with tie
down straps while the motorhome is in motion.
020229b
020163d