EasyManua.ls Logo

Monaco Cayman 2005 - Engine Oil

Default Icon
396 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chassis Information --- Section 10
Cayman 2005
353
Engine Block Heater:
The block heater cord is located in the rear engine com-
partment. The block heater, depending on engine size, is rated
between 850-1500 watts. The block heater cord may be con-
nected to a separate power cord as long as the power cord is
rated for 1500 watts and the outlet used must have a GFCI
protected rate of 20 Amps. The engine may require several
hours of pre-heating before it will start. It is recommended to
start pre-heating the engine the night before departure.
Remember to unplug the separate power cord.
WARNING:
Do not use ether cold starting aids to aid in
starting the engine as engine damage may occur.
Following the maintenance guidelines in the engine manu-
facturer OEM Manual recommendations for the engine will
help to extend engine life and improve performance, resulting
in cost efficient operations. A good maintenance schedule
begins with a daily awareness of the engine and its various
systems.
ENGINE OIL
Following the maintenance guidelines in the Cummins Operation & Maintenance Manual recommendations
for the engine will help to extend engine life and improve performance, resulting in cost efficient
operations. A good maintenance schedule begins with a daily awareness of the engine and its various
systems.
A high grade 15W-40 multiviscosity heavy duty lubricating oil meeting Cummins Engineering
Specification CES 20071 or CES 20076, or American Petroleum Institute (API) specification CH-4 that
can be used as an alternative to CES 20071 is recommended. API CG-4 is acceptable and should not
exceed 75% of the standard drain interval. A critical factor in maintaining engine performance and
durability is the use of high grade multigrade lubricating oil and strict adherence to the maintenance
service intervals.
Shortened drain intervals may be required as determined by a close monitoring of the lubricating oil
condition by means of an oil sampling program. The use of oil analysis to extend the drain interval is
not recommended. There are numerous variables which is the basis of the recommendation.
NOTE:
The engine is filled with 15W-40 oil from the factory.
090397
Block Heater located in Engine Compartment.
Block Heater
cord from
Engine Block

Table of Contents

Related product manuals