Section 5 --- Equipment
Cayman 2005
176
To Retract the Bedroom Slide-out:
• Check for sufficient clearance inside the motorhome before retracting the slide-out room.
• Clean the floor, if applicable, to ensure there is no dirt or grit that could result in floor dam-
age during slide-out retraction.
• Remove any debris from the top of the slide-out room.
• Prior to retracting the slide-out room, start the motorhome. Allow the air bags to fully inflate
to normal travel height.
• Retract the leveling system or prepare the air leveling system for travel prior to operating the
slide-out.
• Turn the ignition switch OFF. The slide-out room will not operate with the engine run-
ning.
• The house batteries are fully charged.
• The battery cut-off switch must be in the ON position.
• Locate the control switch for the slide-out, usually located on the monitor panel, or on the
bedroom wall.
• Clear all people, pets and objects from the slide-out room path.
• Press and hold the switch in the IN position. The slide-out room will move slowly IN. To
stop the slide-out room movement, release the switch. To resume the room movement, push
and hold the switch in. The motor will change sound when the slide-out room is fully
retracted.
• Release the switch.
• Rain water can pool on the slide-out awning. Added weight will cause the awning to sag.
Upon retracting the room, the material can catch between the top of the slide room and the
opening in the motorhome. It will be necessary to retract the room in small increments, allowing
the water time to run off.
CAUTION:
Continuous operation of the slide-out room can drain the battery and damage the
slide-out motor from overheating. Never move the motorhome without having the
slide-out room retracted.
Manual Override - Bedroom Slide-out
If the slide-out room does not respond from the switch, check that all the safety features are in place.
• The ignition key is OFF.
• The battery cut-off switch is ON.
• The house batteries are fully charged.
To Next Page
Loading...
