Section 8 --- Electrical Systems - House
Cayman 2005
256
Plugging in the Shore Cord:
• Located in the roadside compartment is the shore power cord.
• Unscrew the deck plate and insert the end of the shore cable
through the deck plate.
• If 50 Amp service is not available, install the proper electrical
adapter(s) to the opposite end of the cord.
• Always turn off the shore power breaker to the power supply
outlet before connecting or disconnecting the
shore cord. This will prevent an accidental
shock and flashing of electrical contacts.
• Make the connection to the outlet and turn the
shore power breaker on. The transfer switch
should make an audible click.
• Ensure AC In is lit on the inverter remote
panel inside the motorhome.
Plugging in the Shore Cord with Cord Reel
Option:
• Located in the roadside compartment is the shore power
cord.
• Extend the cable by extending a sufficient amount of
cable to reach the power supply. If 50 Amp service is not
available, install the proper electrical adapter(s) to the
cord.
• Always turn off the shore power breaker to the power
supply before connecting or disconnecting the shore
cord. This will prevent an accidental shock and flashing
of electrical contacts.
• After the connection is made, turn the shore power
breaker on. The transfer switch should make an audible
click.
• Ensure AC In is lit on the inverter remote panel inside
the motorhome.
Disconnecting the Shore Cord:
• Turn off all AC appliances. This will prevent accidental shock and flashing of electrical
contact when disconnecting.
• Turn off the shore power breaker.
• Grasp housing of electrial cord. Without touching electrical contacts, work cord out and
away from socket.
• Straighten and clean cord.
• Stow in Compartment.
060203
060212c
060213g
To Next Page