6. Adjust the supply holder guides so the sides barely touch the roll. Make
sure the supply roll turns freely.
7.
Push down on the supply lever to unlock the supply guides. The supply
guides have been angled slightly for string tag supplies.
8. Lay the supply across the supply guide so that a few inches extend past
the front of the printer. Tuck the supply under the nibs and in between
the die cut sensor.
9. Adjust the supply guides so they touch the supply. Push up on the supply
lever to lock the supply guides into place.
Nib
Supply Lever
Die Cut
Sensor
2-16 Operator's Handbook
To Next Page
Loading...
