High Energy Ribbon Limitations
When using the high energy ribbon option:
Use a print speed of 2.5IPS (inches per second).
Printhead warranty is reduced to 100,000 inches.
Serial bar codes cannot be printed.
Do not use peel mode.
No more than 20% of the supply should have print (black coverage).
CAUTION: The high energy ribbon may break or stick to the supply when
more than 20% of the supply contains print.
Only white high energy supply should be used for bar code printing.
Reverse fonts cannot be used.
A non-printing area of at least .1 inch (2.54 mm) must exist on the left
and right edge of the ribbon.
Do not print horizontal lines or bars.
Graphics are limited.
Loading Ribbon 3-5
To Next Page
Loading...
