Monarch 9855 - Setting Batch Options; Setting up the Network Printer; Setting up the RFID Printer

6-14 Operator's Handbook
Setting Batch Options
You can select Batch Options to change, which prompts appear during Batch
Entry mode and set default values for those prompts. Customizing which
prompts appear during batch entry can reduce the time it takes to enter data
for a format. If the optional knife is not installed, you can prevent those
prompts from appearing during batch entry mode. If you set a new default
value for an option, that value is used even if the prompt is not displayed. If
you do not change a default value for an option, the system default is used if
the prompt is not displayed.
Note: Setting batch options requires the optional keypad, which must be
purchased separately.
Refer to your keyboard's Operating Instructions for more information.
Setting Up the Network Printer
Your System Administrator should refer to the MonarchNet2  Operating
Instructions (available on our Web site) for more information about your
network printer.
Setting Up the RFID Printer
Your System Administrator should refer to the Multi-Protocol Application
Notes (available on our Web site) for more information about setting up your
RFID printer.