2. Press Enter/Pause. The current setting is displayed, for example:
PROMPT SET
English
3. Press or until you see the option you want. Then press
Enter/Pause. Press Escape/Clear until you see the Main menu.
Note: This option only affects the displayed prompts. It does not change
what is printed by the printer.
Using Flash Storage
Flash storage allows packets (with "R" or "N" selectors) to be stored in flash
memory, instead of volatile RAM. Packets stored in flash memory are saved
when the printer is turned off. However, flash memory storage is limited.
Note: You must format flash memory before enabling this option.
Formatting flash memory is only required once during initial printer
setup.
To change the setting, from the Main Menu, select Setup, then Defaults.
Then, follow these steps.
1. Press until you see
DEFAULTS
Flash Storage
2. Press Enter/Pause. The current setting is displayed, for example:
FLASH STORAGE
Disabled
3. Press or until you see the option you want. Then press
Enter/Pause. Press Escape/Clear until you see the Main menu.
Setting Defaults 6-7
To Next Page
Loading...
