Monarch 9855 - Page 6

Adjusting the Wide/Narrow Knobs........................................................... 2-17
LOADING RIBBON.......................................................................................3-1
Loading Ribbon....................................................................................... 3-2
Using a High Energy Ribbon ....................................................................3-4
High Energy Ribbon Limitations.............................................................3-5
SETTING SUPPLY OPTIONS......................................................................... 4-1
Setting the Supply Type...........................................................................4-3
Setting the Ribbon ..................................................................................4-4
Setting the Speed ...................................................................................4-5
Setting the Feed Mode ............................................................................ 4-6
Setting the Backfeed...............................................................................4-7
Changing the Position Settings................................................................. 4-8
Setting the Print Position...................................................................... 4-8
Setting the Supply Position................................................................. 4-10
Setting the Margin Position................................................................. 4-11
Setting the Cut Position...................................................................... 4-12
Setting the Dispense Position ............................................................. 4-13
Setting the Backfeed Distance ............................................................ 4-13
Using Batch Separators......................................................................... 4-15
Using Skip Index................................................................................... 4-16
Setting the Knife Control........................................................................ 4-17
Setting the Error Action ......................................................................... 4-18
Setting the Print Contrast ...................................................................... 4-20
Enabling the Verifier ............................................................................. 4-22
SETTING COMMUNICATIONS....................................................................... 5-1
Setting the Baud Rate .............................................................................5-2
Setting the Word Length ..........................................................................5-2
Setting the Stop Bits ...............................................................................5-3
ii Operator's Handbook