Monarch NICE 5000 User Manual

6 Function Code Table NICE5000 User Manual
- 108 -
Function
Code
Parameter Name Setting Range Default
Unit
Property
F6-10
Elevator function
selection 2
Bit0: Door open/close holding at
open limit
Bit1: Cancelling door open/close
command at a delay after door
open/close limit
Bit2: Cancelling door open/close
command cancelled immediately
at door open/close limit
Bit3: Not judging door lock state
at door close output
Bit4: Auto reset for RUN and
brake contactor stuck
Bit5: Forced door close
Bit6: Manual door
Bit7: Cancelling door lock auto-
reset
Bit8: NO/NC output selection of
shorting PMSM stator contactor
Bit9: Door lock circuit contactor
output monitoring
Bit10: Cancelling overspeed
protection
Bit11: Car call executed rst
Bit12: Car call assisted command
in single door used as disability
function
Bit13: Folding command used as
disability function and back door
function
Bit14: Car call command folding
Bit15: Higher/Low voltage 1.5s
time detection
18
-
★

Monarch NICE 5000 Specifications

General

Brand	Monarch
Model	NICE 5000
Category	Controller
Language	English