Moog CURLIN INFUSION PainSmart - Bolus Cord Use; Figure 2.13 Attaching and Removing the

35
B
A P
S
U
K
Bolus Cord Use
When the PCA therapy is used, patient bolus dosing can be programmed. To facilitate ease of
patient self-dosing, the patient can use the Bolus Key or the Remote Bolus Access Cord. When a
bolus dose is requested two beeps will sound to indicate that the dose has started. If a bolus dose is
requested and denied, one beep will sound. When a bolus dose is completed, no beep will occur.
The cord is five feet long and has a patient access button at the top of the remote cord. The four-
pin adaptor with the unique key plugs into the four-hole port with the matching keyhole on the
left side of the pump (see Figure 2.13 below). This port may be covered with a plastic plug. If so,
remove the plug to access the port. To remove the cord, pull back on the soft, green locking sleeve
and disengage the cord from the pump by pulling it straight out of the access port.
Figure 2.13 Attaching and Removing the Remote Bolus Cord
Pump & Set Features