49
Selecting “BIOMED SETUP” allows the pump to be programmed and customized by the
clinician to perform a number of special functions including setting the system clock. (See
BIOMED SETUP) Accessing “BIOMED SETUP” requires you to enter a clinician access code.
(Refer to the chapter entitled, “Clinician Information and Access Code,” of this manual.)
Access Code
Clinician Access Code Screen
Depending on the configuration of your pump, the clinician enters a five-digit access code; or
a four-digit personal identification number followed by the five-digit access code; and, if the
code is valid, the display will automatically move to the requested screen or field. The four-digit
personal identification number appears on the screen but the access code numbers do not; instead
five asterisks appear. If the “four-five” configuration is selected, the personal identification
number is recorded in the history file for the purpose of providing an audit trail. If an invalid
code is accidentally entered, a message displays “INVALID CODE” and the clinician can reenter
the correct code.
Note: After entering the access code, DO NOT press the YES/ENTER key. The pump will
automatically recognize the correct code and give you access to the secured section.
If an access code screen displays and the access code is not known,
use the down arrow to move the cursor to the “EXIT?” field. Press
the YES/ENTER key at this field to return to the previous screen
and make another selection. Also, remember that the HELP key is
available when the pump is paused.
Look first at the BioMed SETUP menu and its special customization features:
BioMed Setup
BioMed Setup Menu
IMPORTANT
INFORMATION
Basics Programming
To Next Page
Loading...
