Moog CURLIN INFUSION PainSmart - Stopping the Infusion; Pause Menu Screen

79
2. A completely filled in bar graph indicating infusion complete.
3. TOT Vol (Total Volume): If units are mg or mcg, this field will also toggle to give the “Total
Infused.”
4. “Infusion Complete” is considered an alarm status, and the audio alarm will beep periodically
every three seconds to alert the user to this condition. Additionally, the red LED light blinks to
indicate that the “Infusion Complete” alarm exists.
Stopping the Infusion
At “Infusion Complete,” press the PAUSE key and then choose to either:
1. Turn off the pump by pressing the OFF key, or
2. Select one of the options from the Pause screen:
Pause Menu Screen
a. REPEAT Rx: To repeat the present therapy and add another IV container with the same
prescription, press the YES/ENTER key at this eld. e following screen will then appear,
asking whether or not you wish to maintain the current “Bolus or MedLMTS
™ Schedule.”
Press YES/ENTER to maintain the current schedules and continue with the programming
of the pump. Press NO/CHANGE to start a new schedule. e following screen will then
appear asking you to conrm the clearing of the schedules.
Press YES/ENTER to clear the current schedules and continue with the programming of
the pump. Pressing NO/CHANGE will return you to the prior screen.
e pump will then display the program screens with the last programmed values of the
therapy and the cursor will automatically advance through the prescription menus. You can
stop the auto-advance function by pressing any key (except ON/OFF) and then complete
the conrmation of the prescription manually by pressing the YES key at the remaining
elds.
PCA Therapy