Morgana CT620Exa - Selecting the rear edge margin cut

48
ԡ Selecting the rear edge margin cut
This selection is valid when a free format was selected.
٤ LCD display for rear edge margin cut selection
LED display Power LED: ON, READY : OFF, ERROR: OFF
No. Display information Display Changes
Ԙ Shows the rear edge margin cut selection INOP (Fixed screen)
ԙ Use to select the rear edge margin cut. Switches between
"Yes" or "No" each time the rear edge margin cut UP/DOWN
switch is pressed.
OK
Ԛ An "H" is shown when the displayed setting has been saved. A
blank space is shown when in the setting change state.
OK. Shows "H" or
blank display.
Note1 : The only location settable by the user is ԙ .
٤ Rear edge margin cut select switches
Switches Description
UP - DOWN Use to select rear edge margin cut. Enabled by ԙ .
ENTER Use to enter the display information. (After entering, an "H" ap-
pears in Ԛ ).
CLEAR Shows the default (reset value).
MENU Setting Entry mode; Shifts to Menu screen 1.
Note 1: The data changes are not entered (stored) if the Menu switch is pressed before the
Enter switch was pressed.
Note 2: If an error such as Cover-Open was detected before pressing the Enter switch then
after eliminating the error, operation shifts to Standby mode without storing any
changes.
No
9. Bottom Space