47
Ԡ Setting the number of prints per sheet with the long blade cut
This setting is valid when a free format was selected.
٤ LCD display for the setting of the number of prints per sheet with the long blade cut
LED display Power LED: ON, READY : OFF, ERROR: OFF
No. Display information Display Changes
Ԙ Shows the status of the setting of the number of prints per
sheet with the long blade cut.
INOP (Fixed screen)
ԙ Shows the setting of the number of prints per sheet with the
long blade cut. Move up and down along the fi gures to enter a
number.
OK
Ԛ An "H" is shown when the displayed setting has been saved. A
blank space is shown when in the setting change state.
OK. Shows "H" or
blank display.
Note1 : The only location settable by the user is ԙ .
٤ Switches for the setting of the number of prints per sheet with the long blade cut
Switches Description
UP - DOWN Use to make the setting of the number of prints per sheet with
the long blade cut. Enabled by ԙ .
ENTER Use to enter the display information. (After entering, an "H" ap-
pears in Ԛ ).
CLEAR Shows the default (reset value).
MENU Setting Entry mode; Shifts to Menu screen 1.
Note 1: The data changes are not entered (stored) if the Menu switch is pressed before the
Enter switch was pressed.
Note 2: If an error such as Cover-Open was detected before pressing the Enter switch then
after eliminating the error, operation shifts to Standby mode without storing any
changes.
8. Cutter-H Mapping
To Next Page
Loading...