46
ԟ Selecting the paper skew offset
٤ LCD display for paper skew offset ON/OFF
LED display Power LED: ON, READY : OFF, ERROR: OFF
No. Display information Display Changes
Ԙ Shows the paper skew offset select status. INOP (Fixed screen)
ԙ Shows the paper skew offset ON/OFF status. Press the UP/
DOWN switch to change the display.
Press the UP/DOWN switch to make one of 2 selections as fol-
lows.
ON : Paper skew offset on OFF : Paper skew offset off
OK
Ԛ An "H" is shown when the displayed setting has been saved. A
blank space is shown when in the setting change state.
OK. Shows "H" or
blank display.
Note1 : The default for Paper Skew on/off is "ON" regardless of the rotary blade type.
Note2 : The only location settable by the user is ԙ .
٤ Paper skew offset switches
Switches Description
UP - DOWN Use for selecting the paper skew offset. Enabled by ԙ .
ENTER Use to enter the display information. (After entering, an "H" ap-
pears in Ԛ ).
CLEAR Shows the default (reset value).
MENU Setting Entry mode; Shifts to Menu screen 1.
Note 1: The data changes are not entered (stored) if the Menu switch is pressed before the
Enter switch was pressed.
Note 2: If an error such as Cover-Open was detected before pressing the Enter switch then
after eliminating the error, operation shifts to Standby mode without storing any
changes.
٤ How to select Paper Skew Offset ON/OFF
The default setting for Paper Skew Offset ON/OFF is "ON". Use while in "ON" for normal cut-
ting.
The luster of the paper surface might sometimes change after cutting if Paper Skew Offset is
"ON" when using coated paper such as output from an electronic photographic printer. If this
should happen set the paper skew offset to "OFF".
Paper Skew Offset is a function where the paper edge is corrected perpendicular to the
long blade before cutting at the point where the edge of the paper contacts the roller before
reaching the long blade.
To Next Page
Loading...
