If there is a solid location signal during Emergency operation, the current location and the location
information received is saved as Emergency and Last Known Location respectively.
6.20.15
Peer-Location on the Display (ASTRO Conventional)
This feature is only available for radio-to-radio voice transmissions, dispatch call and selective call.
Both the transmitting radio and receiving radio must be configured to enable them to send and receive
the GPS coordinates.
NOTE: If the receiving radio is operating in a Mixed Mode channel, only if its voice transmission
is through conventional ASTRO system then the radio can receive the location coordinates of
the peers.
This feature is also operable in a Scan Active channel or Scan Talkback channel.
After receiving a voice transmission with GPS coordinates enabled on the receiving radio, the display
shows the coordinates available in full or in short coordinates.
Full location coordinates
• PTT ID (optional)
• Longitude and latitude
• Relative distance or direction
Short location coordinates
• PTT ID (optional)
• Longitude and latitude
NOTE:
If the transmitting radio is stale at the location after a period, the receiving radio display shows
the last known location. If the transmitting radio does not have GPS or the receiving radio could
not decode the GPS signal of the received signal, the receiving radio display shows the location
as unknown.
6.21
Mission Critical Geofence (ASTRO 25 Trunking)
This feature allows the radio to use the GPS receiver to determine its location at frequent intervals and
evaluate if the radio is within the Geofence area in real time. Geofence is a virtual perimeter based on
the GPS to define a geographical area on earth.
When the radio enters the predefined Geofence area, your radio receives the Dynamic Regroup
command from the system and immediately connects to a Dynamic Regroup talkgroup. The radio
display shows the new selected Dynamic Regrouped talkgroup with green intelligent light for your
attention. Voice Announcement is also available to support this feature.
Any new text messages received at Geofence is displayed immediately on the radio display.
NOTE:
If the radio is set up in DVRS, only mobile radio is supported for this feature.
6.21.1
Entering the Geofence Area
Prerequisites:The Voice Announcement and TMS display in this feature are optional. They must be
configured to enable you to hear and see these indicators.
MN006147A01-AE
Chapter 6: Advanced Features
95
To Next Page
Loading...
Need help?
General
