6.22.3
SmartConnect
SmartConnect allows your radio to maintain voice communication when LMR is out of range by
switching to a Wi-Fi, LTE through Tethered Data Modem and Satellite through Ethernet.
Before switching broadband connections, your radio compares the relative signal strength of the
various broadband connection types to one another, as well as LMR. Your radio remains or returns
to LMR connection when the other broadband connections fall below the quality threshold. In addition,
a radio operating on a lower priority broadband connection returns to the higher priority or quality
connection while idle on SmartConnect.
NOTE: This feature must be preprogrammed by a qualified radio technician. Contact your
system administrator for more details of supported radio models.
Your radio can connect through a fixed Wi-Fi access point in buildings or in-vehicle Broadband modem
such as the following modems:
• Motorola Solutions VML750
• Sierra Wireless MP70
• Sierra Wireless GX450
Your radio displays the SmartConnect capable icon on the SmartConnect enabled channel, once
the device is connected to an available network, the radio displays SmartConnect connection icon
.
Your radio displays OUT OF RANGE when both LMR and SmartConnect are unavailable.
6.22.4
SmartZone
The SmartZone
™
feature extends communications beyond the reach of a single-trunked site (antenna
location) when operating in a SmartZone system. SmartZone units provide expanded wide-area
coverage.
SmartZone automatically switches the radio to a different site when the current site signal becomes
unacceptable. This usually happens when the vehicle in which the radio is located is driven out of the
range of one site, and into the range of another.
Under normal conditions, a SmartZone-enabled radio functions invisibly to the operator. However, the
operator does have some manual controls on the Control Head–the RSSI menu entry. This button can
be used to check, or change, the SmartZone operation.
6.22.5
Site Trunking Feature
If the Zone Controller loses communication with any site, that site reverts to site trunking. When this
occurs, you can communicate only with the radios within your trunking site.
The display shows the currently selected zone/channel and the Site Trunking message.
6.22.6
Locking and Unlocking a Site
When and where to use:This feature allows your radio to lock onto a specific site and not roam
among wide-area talkgroup sites. This feature should be used with caution, since it inhibits roaming to
another site in a wide-area system.
MN006147A01-AE
Chapter 6: Advanced Features
98
To Next Page
Loading...
Need help?
General
