2.3
Validating Compatibility During Power Up
The radio validates and updates the software and hardware of your control head(s) during power-up.
During validation, the display shows Maintenance Mode Remote Device promptly followed by
other maintenance statuses.
Procedure:
Press the Power On/Off Button to reset when the display shows Update done Please
reset upon completion, or when the display shows Update failed Please reset when it
fails to update.
If the updates are incomplete, the radio runs the Maintenance Mode and the display shows
Maintenance Mode Remote Device; promptly followed by other maintenance statuses again.
MN006147A01-AE
Chapter 2: Preparing Your Radio for Use
19
To Next Page
Loading...
Need help?
General
