a. To route the audio routing from the radio to the headset, press the preprogrammed
Bluetooth Audio Reroute button.
You hear a short, medium-pitched tone. The display shows BT on.
BT audio routing can be configured in CPS to route the audio to RSM or radio's internal speaker.
The audio routes to the radio's speaker if RSM is not connected. Check with your dealer or
system administrator for more information on the programming of this feature.
NOTE: For BT PTT press, the active microphone can be configured in CPS to transmit
from either the RSM, the radio microphone, or the BT headset. If the configured device
is not available, audio transmission reverts to BT headset.
For Bluetooth devices, the display shows BT.
For Wireless-Pair devices, the display shows WP.
6.24.7
Turning Off the Bluetooth Audio
When and where to use:Do one of the following to turn off the Bluetooth Audio. You can use the
options interchangeably depending on your preference and the programmed functions.
Procedure:
• Turning off the Bluetooth audio using the radio menu BT:
a.
or to BT. Press the Menu Select button directly below BT to access the Bluetooth feature
screen.
b. or to Bluetooth spkr and press the Menu Select button directly below Off.
The display shows Off.
c. To return to the Home screen, press the Menu Select button directly below Exit.
• Turning off the Bluetooth audio using the preprogrammed button:
a. To route the audio routing from the headset to the radio, press the preprogrammed
Bluetooth Audio Reroute button.
You hear a short, medium-pitched tone. The display shows Radio audio.
For Bluetooth devices, the display shows BT.
For Wireless-Pair devices, the display shows WP.
6.24.8
Adjusting the Volume of the Radio from Bluetooth Audio Device
Prerequisites:Ensure that the Bluetooth audio device is connected to the radio.
When and where to use:
MN006147A01-AE
Chapter 6: Advanced Features
108
To Next Page
Loading...
Need help?
General
