6.12.3
Exiting Emergency Operation
If an Emergency operation is triggered on your radio, the dispatch console or radios configured as
Supervisor can exit the Emergency operation.
Procedure:
To exit Emergency operation, press and hold the programmed Emergency button.
6.12.4
Exiting Emergency as Supervisor (Trunking Only)
Radios configured as Supervisor are able to cancel emergency mode of other radios. The dispatch
console must be preprogrammed to use this feature. Contact your system administrator for more
information.
Procedure:
1 Perform one of the following actions:
If… Then…
If the emergency mode is
initiated by other radios,
press and hold the Accy No-Dot Button (Purple) button
and press the Emergency button.
If the emergency mode is
initiated by the Supervisor,
Perform one of the following actions:
• Press and hold the Emergency button.
• Press and hold the Accy No-Dot Button (Purple), and
press the Emergency button.
• Wait for console to clear emergency.
NOTE: The combinations of the following buttons are supported in your radio:
• Radio Accy No-Dot Button (Purple) and Emergency button.
• Radio Accy No-Dot Button (Purple) and accessory Orange button.
• Accessory 1-Dot Button and radio Emergency button.
• Accessory 1-Dot Button and accessory Orange button.
6.12.5
Sending an Emergency Alarm
When and where to use:This feature allows you to send a data transmission, which identifies the
radio sending the emergency, to the dispatcher.
Procedure:
1 Press the preprogrammed Emergency button.
A tone sounds, the LED blinks red momentarily, and the radio displays EMERGENCY. A
dispatcher acknowledgment Ack received display follows. For trunking system, the radio also
sounds a high-pitched tone that indicates the alarm is received by the central controller of the
trunked system.
2 Press and hold the Emergency button or the PTT button to return to normal operation.
MN006147A01-AE
Chapter 6: Advanced Features
65
To Next Page
Loading...
Need help?
General
