• Press the Menu Select button directly below Ok to save the new Friendly Name and return to
the Bluetooth feature screen.
• Press the Menu Select button directly below Cncl to return to the Bluetooth feature screen.
For Bluetooth devices, the display shows BT.
For Wireless-Pair devices, the display shows WP.
6.25
ASTRO 25 (P25) Programming Over Project 25 (POP25)
Also called Over-the-Air Programming, this feature allows configuration data and firmware to be
upgraded to your radio over-the-air. Full use of the radio is retained during the data transfer without
interrupting communication.
If the upgrade happens on the ASTRO 25 and ASTRO Conventional systems, the upgrade pauses to
give priorities to voice call, and continues after the voice call ended. If the upgrade happens on a Wi-Fi
network, the upgrade process runs concurrently with voice calls.
Once a configuration upgrade is downloaded to your radio, you can install new changes immediately or
delay changes to be installed on the radio when it is being powered up.
6.25.1
Responding to the Notification of Upgrade
Procedure:
1 The display shows Upgrade? and two short, medium- pitched tones sound every 30 seconds
until the user makes a choice of either accepting, delaying, or rejecting the request.
NOTE: Do not remove the power cable or power down the radio during the firmware
upgrade process.
2 Perform one of the following actions:
One of the following scenarios occurs:
• If you choose to accept, the display shows Programming Dont power off to indicate that the
upgrade is about to begin. The radio resets to install the upgrade. In the case of configuration data
upgrade, the process only takes a few seconds. In the case of firmware upgrade, the installation
takes several minutes.
NOTE: The radio cannot be used while the upgrade is being installed. Therefore, make sure
to only accept the upgrade at a convenient time when immediate radio use is not required.
• If you choose to delay, a configuration data upgrade is installed automatically at the next power up.
However, in the case of a firmware upgrade, the radio prompts Upgrade? again at the next power
up.
• If you choose to reject, the display shows Upg Aborted. The radio continues to function with the
current configuration until it gets reprogrammed.
NOTE: If your radio has problems upgrading over-the-air, consult a qualified technician for
details.
6.26
Voice Announcement
This feature enables the radio to audibly indicate the current feature mode, zone, or channel assigned
to the user.
MN006147A01-AE
Chapter 6: Advanced Features
111
To Next Page
Loading...
Need help?
General
