Motorola ET1 - Disable the Multi-User Feature; Enable Remote Authentication

7 - 8 ET1 Enterprise Tablet Integrator Guide
Figure 7-7 MultiUser Login Screen
4. In the Login text box, enter the username.
5. In the Password text box, enter the password.
6. Touch OK.
Disable the Multi-user Feature
To disable the Multi-user feature:
1. Touch > MultiUser Administrator.
2. Touch Disable MultiUser. The Multi-user feature is disabled immediately.
3. The ET1 suspends. When resumed, the single-user home screen appears.
Enable Remote Authentication
To enable remote authentication:
1. Touch > MultiUser Administrator.
2. Touch Load Server Info. The application reads the data from the server file and configures the Multi-user
Login feature.
3. Touch .
4. Touch Enable Remote Authentication. The ET1 accesses the remote server and then Login screen
appears.
NOTE To disable the Multi-user Login feature, the user must have administrator rights. A message displays at
the bottom of the screen notifying the user.
CAUTION When Remote Authentication is enable, the ET1 searches for the remote server during the login
procedure. If the remote server is not available or the address is incorrect, the user would not be able
to login and an Enterprise reset is required to access the ET1.