WLAN Configuration 5 - 3
5. Touch .
Manually Adding a Wi-Fi Network
Manually add a Wi-Fi network if the network does not broadcast its name (SSID) or to add a Wi-Fi network
when out of range.
1. Touch > Settings > Wireless & networks.
2. Touch Wi-Fi to turn Wi-Fi on.
3. Touch Wi-Fi settings.
4. Touch Add Wi-Fi network. The Add Wi-Fi network dialog box appears.
5. In the Network SSID text box, enter the name of the Wi-Fi network.
6. In the Security drop-down list, select the type of security. Options: Open, WEP, WPA/WPA2 PSK or
802.1x EAP.
•
If the network security is Open, touch Save.
•
If the network security is WEP or WPA/WPSA2 PSK, enter the required password and then touch Save.
•
If the network security is 802.1x EAP:
• Touch the EAP method drop-down list and select LEAP, FAST, PEAP, TLS or TTLS.
• Touch the Phase 2 authentication drop-down list and select an authentication method.
• If required, touch CA certificate and select a Certification Authority (CA) certificate.
Note: Certificates are installed using the Location & security settings.
• If required, touch User certificate and select a user certificate.
Note: User certificates are installed using the Location & security settings.
• If required, in the Identity text box, enter the username credentials.
• If desired, in the Anonymous identity text box, enter an anonymous identity username.
• If required, in the Password text box, enter the password for then given identity.
• Touch Save.
7. Touch .
Advanced Wi-Fi Settings
Use the Advanced settings to configure additional Wi-Fi settings. Touch > Advanced to view the
advanced settings.
NOTE Advanced Wi-Fi settings are for the device not for a specific wireless network. If using the ET1 in one
location that requires a proxy and then moving to another location that does not require a proxy, the proxy
must be disabled.
To Next Page
Loading...
