Motorola ET1 - Configure a Wi-Fi Network

5 - 2 ET1 Enterprise Tablet Integrator Guide
Configure a Wi-Fi Network
To set up a Wi-Fi network:
1. Touch > Settings > Wireless & networks.
2. Touch Wi-Fi to turn Wi-Fi on.
3. Touch Wi-Fi settings. The ET1 searches for WLANs in the area and lists them under Wi-Fi networks.
4. Scroll through the list and select the desired WLAN network. The Security dialog box appears.
Figure 5-1 WLAN Network Security Dialog Boxes
• If the network security is Open, touch Connect.
• If the network security is WEP or WPA/WPSA2 PSK, enter the required password and then touch
Connect.
• If the network security is 802.1x EAP:
• Touch the EAP method drop-down list and select LEAP, FAST, PEAP, TLS or TTLS.
• Touch the Phase 2 authentication drop-down list and select an authentication method.
• If required, touch CA certificate and select a Certification Authority (CA) certificate.
Note: Certificates are installed using the Location & security settings.
• If required, touch User certificate and select a user certificate.
Note: User certificates are installed using the Location & security settings.
• If required, in the Identity text box, enter the username credentials.
• If desired, in the Anonymous identity text box, enter an anonymous identity username.
• If required, in the Password text box, enter the password for then given identity.
• Touch Connect.