Motorola ET1 - Using FileXP for File Management

Accessories 2 - 19
Replacement Bezel
To replace the bezel:
1. Press the Power button until the Device options menu appears.
2. Touch Power off.
3. Remove the battery.
4. Place the ET1 face down on a table.
5. Remove two plugs covering the screws.
6. Using a Torx T6 screwdriver, remove four Torx screws.
Figure 2-19 Remove Screws
7. Using tool, pry bezel from top of ET1.
8. Lift bezel from ET1.