Motorola ET1 - Define an Action; Delete a Rule

4 - 24 ET1 Enterprise Tablet Integrator Guide
11. Touch Source criteria option to associate an input device to an ADF rule. The ADF rule only applies to
data received from associated input devices.
12. Touch Barcode input or MSR input. Options vary depending upon the device configuration.
13. Touch the Source enabled checkbox to accept data from this source.
Figure 4-15 Barcode Input Screen
14. For Barcode inputs, touch the All decoders enabled checkbox to select all bar code symbologies.
Deselect the All decoders enabled checkbox and then individually select the symbologies.
15. Touch . until the Rule screen appears.
16. If required, repeat steps to create another rule.
17. Touch until the Rule screen appears.
Define an Action
By default the Send remaining action is in the Actions list. To add an action:
1. Touch > New action.
2. In the New action menu, select an action to add to the Actions list. See Table 4-1 list the supported ADF
actions.
3. Some Actions require additional information. Touch the Action to display additional information fields.
4. Repeat steps to create more actions.
5. Touch .
6. Touch .
Delete a Rule
To delete an existing rule:
1. Touch and hold on a rule until the context menu appears.
2. Touch Delete to delete the rule from the Rules list.
NOTE When there is no rule available for ADF plug-in or all rules are disabled, DataWedge passes decoded data
to the output plug-in without processing the data.