DataWedge Configuration 4 - 9
Enabled
Enables or disables this plug-in. A check in the checkbox indicates that the plug-in is enabled.
Scanner Selection
Configures which scanning device to use for bar code data capture when the profile is active.
•
Auto - The software automatically determines the best scanning device. If a Scan Module or Scan/MSR
Module is installed on the ET1, then the 2D imager is selected. Otherwise the camera is selected.
•
Camera scanner - Scanning is performed with the rear-facing camera.
•
2D Imager - Scanning is performed using the installed Scan or Scan/MSR module.
Decoders
Configures which bar code decoders are enabled or disabled. For best performance disable all unnecessary
decoders.
Touch Decoders. The Barcode input screen appears. A check in the checkbox indicates that the decoder is
enabled. By default the most commonly used decoders are enabled (shown below with an asterisk). The
supported decoders are:
•
UPC-A* UPC-E0* EAN-13*
•
EAN-8* Code 128* Code 39*
•
Interleaved 2 of 5 GS1 DataBar* GS1 DataBar Limited
•
GS1 DataBar Expanded* Datamatrix* QR Code*
•
PDF417* Composite AB Composite C
•
MicroQR Aztec* Maxicode*
•
MicroPDF USPostnet USPlanet
•
UK Postal Japanese Postal Australian Postal
•
Canadian Postal Dutch Postal US4state FICS
•
Codabar* MSI Code 93
•
Trioptic 39 Discrete 2 of 5 Chinese 2 of 5
•
Korean 3 of 5 Code 11 TLC 39
•
Webcode Matrix 2 of 5 UPC-E1
Touch to return to the previous screen.
Decoder Params
Use Decode Params to configure individual decoder parameters. Touch Decode Params. The Decode
params screen appears.
Touch the decoder parameter to modify.
To Next Page
Loading...
