CHAPTER 4 DATAWEDGE
CONFIGURATION
Introduction
DataWedge is an application that reads data, processes the data and sends the data to an application.
Basic Scanning
Scanning can be performed using either the Scan Module, Scan/MSR Module or the rear-facing camera.
Using the Scan Module
To capture bar code data:
1. Ensure that an application is open on the ET1 and a text field is in focus (text cursor in text field).
2. Aim the Scan Module exit window at a bar code.
3. Press and hold either Scan/Action button. The red laser aiming pattern turns on to assist in aiming. Ensure
that the bar code is within the area formed by the aiming pattern. The Decode LED lights red to indicate
that data capture is in process.
To Next Page
Loading...
