WLAN Configuration 5 - 5
Figure 5-2
Proxy Settings Dialog Box
4. In the Hostname text box, enter the address of the proxy server.
5. In the Port text box, enter the port number for the proxy server.
6. In the No Proxy for text box, enter addresses for web sites that do not require to go through the proxy
server. Use the separator “|” between addresses.
7. Touch Save.
Remove a Wi-Fi Network
To remove a remembered or connected network:
1. Touch > Setting > Wireless & networks.
2. Touch Wi-Fi settings.
3. In the Wi-Fi networks list, touch and hold the name of the network.
4. In the menu, touch Forget network.
5. Touch .
Static IP Address
By default, the ET1 is configured to use Dynamic Host Configuration Protocol (DHCP) to assign an Internet
protocol (IP) address when connecting to a wireless network. To configure the ET1 to connect to a network
using a static IP address:
1. Touch > Setting > Wireless & networks.
2. Touch Wi-Fi settings.
3. Touch > Advanced.
4. Touch Use static IP checkbox.
5. Touch IP address and enter an IP address for the device and then touch OK.
NOTE When entering exceptions, do not use spaces or carriage returns between addresses.
To Next Page
Loading...
