Getting Started 1 - 9
10. Touch P3.
11. Touch P1 or P2 to navigate to the ET1N0GxxFRxxxxxxx.zip file.
12. Touch P3. The Factory Reset occurs and then the ET1 resets.
Waking the ET1
The wake-up conditions define what actions wake up the ET1 after it has gone into suspend mode or has been
placed in Battery Swap mode. The ET1 can go into suspend mode by either pressing the Power button or
automatically by a time-out settings. These settings are configurable and the factory default settings are shown
in Table 1-2 are subject to change/update.
To set the user configurable wake conditions, touch > Settings > Wake up source.
Figure 1-8
Wake Up Source Screen
Touch the checkbox to enable or disable the wake up condition.
Table 1-2
Wake-up Default Settings
Condition for Wake-up User Configurable Wake from Suspend
Wake from Battery
Swap Suspend
Press the Power button No Yes Yes
Real-time Clock No No Yes
Apply AC power No Yes No
Press the Left or Right
Scan/Action button
Yes Yes No
G-sensor activity Yes Yes No
Bluetooth activity Yes Yes No
To Next Page
Loading...
