CHAPTER 8 SETTINGS
Introduction
This chapter describes settings available for configuring the ET1.
Location Settings
Use the Location & Security settings to set preferences for using and sharing location information. Touch
> Settings > Location & security.
Figure 8-1
Location & Security Settings
Check Use wireless networks checkbox to use information from Wi-Fi networks to determine approximate
location.
GPS can be used in stand-alone or Assisted (A-GPS) modes. A Stone-alone GPS receiver downloads data
from GPS satellites. It can take several minutes to get a fix. By using GPS Location servers, A-PGPS
dramatically improves the performance of the Time To First Fix (TTFF) of GPS receivers by providing them with
NOTE Assisted GPS is only available of ET1N2 WAN configurations.
To Next Page
Loading...
