• All retries to send the alarm have been exhausted.
• Your radio is turned off.
Note:
Your radio does not reinitiate the
Emergency mode automatically when it is
powered up again.
Follow the procedure to exit Emergency mode on
your radio.
Press the programmed Emergency Off button.
Exiting Emergency Mode After Receiving the
Emergency Alarm
Follow the procedure to exit Emergency mode after
receiving Emergency alarm.
Do one of the following:
• Change the channel.
• Power down the radio.
Sending Emergency Alarms
This feature allows you to send an Emergency Alarm,
a non-voice signal, which triggers an alert indication
on a group of radios. Follow the procedure to send
Emergency Alarms on your radio.
1 Press the programmed Emergency On button.
The green LED lights up.
Note:
If programmed, the Emergency Search
tone sounds. This tone is muted when the
radio transmits or receives voice, and stops
when the radio exits Emergency mode.
2 Wait for acknowledgment.
If successful:
• The Emergency tone sounds.
• The green LED blinks.
If unsuccessful after all retries have been
exhausted:
• A low-pitched tone sounds.
The radio exits the Emergency Alarm mode.
Sending Emergency Alarms with Call
This feature allows you to send an Emergency Alarm
to a group of radios. Upon acknowledgement by a
radio within the group, the group of radios can
communicate over a programmed Emergency
40
English
To Next Page
Loading...