Maintenance 6 - 25
Figure 6-25 Cradle Back Housing Assembly Removal
5. Remove the main PCB from the Cradle front housing by unfastenning the two self tapping
screws using a T10 TORX™ screw bit.
6. Remove the spiral cord retainer from the Cradle front housing.
Figure 6-26 Main PCB Removal
7. Unplug the spiral cord cable wire to board connector from the Cradle main PCB. Refer to
Figure 6-27.
Figure 6-27 Spiral Cord Cable Wire Removal
ZWG0130215-O
Spiral cord cable
ZWG0130215-O
Spiral cord retainer
ZWG0130215-O
Main PCB
To Next Page
Loading...
