6 - 26 Maintenance
8. Remove the spiral cord cable from the Cradle front housing by pulling back the strain relief
and carefully push the wire to board connector in vertical position out from the Cradle front
housing as shown in Figure 6-28 below.
Figure 6-28 Spiral Cord Cable Removal from Front Housing
9. Remove the four machined screws from the back of the Handset using a T8 TORX™ screw
bit as shown below.
Figure 6-29 Machined Screws Removal
10. Disassemble the Handset back housing assembly from the Handset front housing assembly.
11. Unplug the Handset LCD flex and keypad flex BTB from the Handset main PCB as shown in
Figure 6-30.
Figure 6-30 LCD and Keypad Flex BTB Removal
Strain relief
Wire to board
connector
Make sure the wire to board
connector is in vertical position
before pulling out from the
front housing
ZWG0130215-O
Machined screws
ZWG0130215-O
To Next Page
Loading...
