E-12 MTR3000 Third Party Controllers: Tone Remote Adapter
E.4.4 CPS Configuration
The MTR3000 Base Station/Repeater will need to be configured via the CPS application as shown in
Figure E-12. More specifically, the affected parameters are as follows:
• Audio Type
- Rx and Tx Filtered Squelch
• Analog Accessory Emphasis
-De & Pre
• Disable Repeat Path
-Un-Checked
• Audio Priority
- Set to “Ext PTT” for console priority
- Set to “Repeat Path” for repeat priority
• GPIO Pin number 2, 11
- Ext Mic PTT
- Active Low
• GPIO Pin number 4
- CSQ Detect or PL/Talk group Detect
- Active Low
• GPIO Pin number 24
-Monitor
- Active Low
• GPIO Pin number 8, 25
- Channel Select 0
- Active Low
• GPIO Pin number 10, 12
- Channel Select 1
- Active Low
• GPIO Pin number 15
- Channel Select 2
- Active Low
• GPIO Pin number 21
- Channel Select 3
- Active Low
• GPIO Pin number 23
- Repeater Disabled (this is optional)
- Active Low
To Next Page
Loading...
Need help?
General
